Principle of work and design

ECOZHAR

The principle of convection

The principle of convection ensures the efficiency of the stove. Natural air convection is ensured by the pipes from which the stove body is welded and which are almost entirely inside the structure.
The cold air flows through the lower openings into the firebox, where it warms up and comes out through the upper openings. The warm air rises up, cools down, and then descends again. These repetitions ensure the process of convection, thanks to which the room warms up quickly enough.

Two-chamber firebox

The two-chamber firebox allows the buller to operate in two modes - smoldering and pyrolysis. The primary chamber burns fuel and produces pyrolysis gases, which are transferred to the secondary chamber, where they are burned.

Thickness of the firebox

In Ekozhar bullerians, special emphasis is placed on the thickness of the firebox metal, which is 8 mm. The metal we use guarantees a service life of at least 10 years.

The firebox door latch

The firebox door handle acts as a lock in the closed position. In this position, the door is tightly pressed, and due to the sealing cord along the contour of the door itself, flue gases cannot enter the room.

Buleryan type 01 Ekozhar (formerly "Brest") for 200 cubic meters

The main advantages of the Ekozhar bullerian

The most important advantages of bullion heaters are their design and principle of operation, which ensure efficient and economical heating of premises, as well as

high efficiency, up to 85%
good heat transfer
fast heating of the room, up to 40 minutes
economical fuel consumption, one full load lasts up to 12 hours of continuous operation
Easy to install, without complicated miscalculations and installations.

Construction of Ekozhar type 01 bullerian

Buleryan is an ideal choice for heating rooms with a volume of up to 200 cubic meters and an area of up to 80 m² with a ceiling height of up to 3 m, such as small country houses, summer cottages, garages, greenhouses, workshops, guardhouses and construction trailers. Firewood and fuel briquettes are the main type of fuel for this bullerian, but wood waste and paper can also be used.

The structure of the woodburner is made of 4 mm thick heat-resistant steel and consists of a firebox body and 7 air ducts with a diameter of 76 mm. The furnace is divided into two compartments: the lower compartment is used for combustion, and the upper compartment is used for afterburning. Thanks to the overlap between these compartments, the flue gases undergo an additional rotation and, after maximum heat removal, go out into the chimney.

The combustion process in the buller is regulated by two dampers: one regulates the air supply to the firebox, the other controls the flue gases. This allows you to quickly warm up the room with the maximum opening of the dampers in 15-20 minutes, or switch to a long burning mode with the dampers closed, which allows you to heat the room for up to 6 hours. The bullpen door is equipped with a heat-resistant cord that prevents smoke from escaping into the room.

Each series and model of our weed killers is developed by a designer to ensure maximum efficiency and productivity. We have mass production of weed killers, which guarantees the quality of each product. And all models have a certificate of conformity.

We are confident in the quality of our products and that you will be satisfied.

Our customers' feedback is a confirmation for both us and you.

Below is just a small part of them

The thickness of the furnace

4 mm

Type of furnace

airborne

Heating volume

200 cubic meters

Heating area

80 sq.m.

Material